![]() I know you're trying to help repairdude but maybe it's me who is not explaining things properly, not a techie remember. Let us know how it goes by following up in the discussion page below. As a general rule-of-thumb, if the unit repair cost exceeds 2/3 the cost of a new comparable unit (in both features and quality), then don't bother fixing it. If none of them are successful, you will need to have the unit repaired, or purchase a new DVD player. Try all things you can do yourself to repair the unit. There are other possibilities for the players failure, such as a defective laser motor (the motor that moves the laser), bad spindle motor (the motor that spins the disc), as will as other various circuit falures that could be the cause.I'd try a cleaning disc first, since the only way to fix this problem is to bring the unit to a service center for repair. In many cases, DVD players with this problem will still be able to read a CD. ![]() After a DVD player has been used for awhile, another common problem is that the laser in the DVD player becomes misaligned, inhibiting its ability to read DVDs.Try both CDs and DVDs, since CDs are easier to read than a DVD. Run the cleaning disc 2 or 3 times, and try it again. You could try a DVD laser cleaner, which is usually a disc that has a tiny brush glued onto it. In many cases, DVD players with this problem can still read CDs. Over time, dust and deposits can accumulate on the laser that reads the disc. In your case, the DVP-S560D is an older DVD player, and I'm sure it has had its fair share of use.If you are uncomfortable doing this, you'll want to bring the DVD player to a service center. If this is the case, you could try to determine the cause of this, which is usually the "hat" above the center of the disc is stuck and needs to be repositioned to lay against the top surface of the DVD. In some cases, it can be difficult to hear the disc spinning, so you could remove the lid of the player to actually see if the disc spins. If you hear no such sound, it is common that the disc is not spinning up, which is why you would recieve a "No Disc" message when a disc has been inserted. After the disc tray has closed, you should be able to hear the disc spinning. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |